INJECTION MOLD P3 2 Fully Positive
In the fully positive molds (FIGURE PP.2b) no allowance is made for placing excess powder in the cavity. If excess powder is loaded, the mold will not close; an insufficient charge will result in reduced thickness of the molded article. A correctly measured charge must therefore be used with this mold梚t is a disadvantage of the positive mold. Another disadvantage is that the gases liberated during the chemical curing reaction are trapped inside and may show as blisters on the molded surface. Excessive wear on the sliding fit surface on the top and bottom forces and the difficulty of ejecting the molding are other reasons for discarding this type of mold. The mold is used on a small scale for molding thermosets, laminated plastics, and certain rubber components
|
